I2M DATALOG PRO UNIVERSAL DATA ACQUISER

I2M DATA ACQUISER

DATALOG PRO

The DataLog Pro is developed on the same electronics as the Chrome Pro2 with which it also shares most of the software.

Designed for those who want the most from their electronics, but without being able to replace the dashboard of their bike.

The DataLog Pro has a fully configurable can bus with acquisition of over 150 channels, integrated lambda controller, 7 analog inputs and integrated TPMS receiver.

Developed from the experience gained from the collaboration with Yamaha in the WSBK, and with the historic Team Pedercini.

Thanks to the use of the same hardware as the Chrome Pro 2, it is able to read and acquire over 128 Can Bus channels alongside the 30 standard ones including speed, rpm, external analogue, tire pressures and temperatures, GPS, gears ...

Its hardware allows to make the channel acquisition completely configurable with a maximum frequency of 500Hz for each channel, thus reaching a total sampling frequency of over 65 kSample / s!

The DataLog Pro can be configured via a USB key but also via a special configuration cable.

The DataLog Pro integrates a 433MHz receiver that allows it to receive the signals of our TPMS sensors by storing up to 4 sensors for each wheel.

It is therefore possible to always monitor the pressure of both tires and the temperature of the rim so as to verify the correct heating with the electric blankets and study the behavior of the temperature during use.

In order to maximize the reception of the TPMS signal, it is possible to remotize the antenna using the special shielded cable and support.

The DataLog Pro incorporates the controller for the BOSCH LUS 4.9 Lambda probe which can then simply be connected to its main wiring.

To its front connector it is possible to connect, in a totally plug & play way, a sensor harness to connect external analog sensors such as potentiometers, brake pressure sensors, infrared temperature sensors.

The DataLog Pro comes with:

- DataLog Pro

- Antenna with 90 degree SMA joint for TPMS receiver

- GPS receiver

- Main wiring

- Extension with support for TPMS antenna

ATTENTION: the I2M TPMS sensors are not compatible with the original Ducati Panigale V2 rims

NOTE: TPMS SENSOR NOT INCLUDED

NB: The photo is purely indicative to demonstrate the quality of the product

FOR ANY INFORMATION DO NOT HESITATE TO CONTACT US